User Manual

48
Function Description
Language
Sets the language for the On-Screen Display (OSD) menus.
See "Using the menus" on page 24 for details.
Projector
Position
See "Choosing a location" on page 13 for details.
Menu Settings
Menu Display Time
Sets the length of time the OSD will remain active after your
last key press. The range is from 5 to 30 seconds in 5-second
increments.
Menu Position
Sets the On-Screen Display (OSD) menu position.
Blank Timer See "Hiding the image" on page 37 for details.
Splash Screen
Allows you to select which logo screen will be displayed
during projector start-up.
Screen Capture
See "Creating your own startup screen" on page 37 for
details.
My Button Sets a hotkey on remote control.
Advanced
Pattern
The projector can display several test patterns. It helps you
adjust the image size and focus and check that the projected
image is free from distortion.
Message
Selecting On displays the current information on the screen
when the projector is detecting or searching for a signal.
Presentation Timer
See "Setting the presentation timer" on page 36 for details.
High Altitude
Mode
A mode for operation in high altitude areas. See "Creating
your own startup screen" on page 37 for details.
DCR
Enables or disables the DCR (Dynamic Contrast Ratio)
function. Selecting On enables the function and the
projector will automatically switch the lamp mode between
normal and economic modes according to the input image
detected.
This function is only available when a PC input signal
is selected.
After enabling DCR, frequent lamp mode switching
may shorten lamp life and noise level will vary during
operation.
Audio Settings See "Adjusting the sound" on page 39 for details.
4. SYSTEM SETTING: BASIC menu
5. SYSTEM SETTING: ADVANCED menu