User guide

32ViewSonic PJ588D/PJ568D/PJ508D
3.
Remove the two screws from the lamp
module [A] and then lift the module
handle up [B].
4.
Pull up rmly to remove the lamp module.
5.
Reverse Steps 1 to 4 to install the new
lamp module.
Note: The lamp module should be oriented
as shown here when replacing.
Resetting the Lamp
After replacing the lamp, reset the lamp hour counter to zero. Refer to the following:
1.
Press the Menu button to open the
Main menu.
2.
Press the cursor  button to move
to the Status menu.
3.
Press the cursor  button to move
to Lamp Hour Reset.
4.
Press the Enter button.
A message screen appears.