Service manual

ViewSonic Corporation Confidential - Do Not Copy PJ513D-1

TABLE 2 : General Product of plastic outlook inspection standard

NO Appearance Spec

1 Shrinkage A region: No Shrink. With gloves, no feeling of sink when touching the surface

B/C region: not obvious

2 Run, Texture, Gloss No obvious non-uniformity

3 Welding Line/Knit Line Follow limit sample level

4 Ejector Mark Reject

5 Label/screws shortage Reject

6 Material shortage Not allow, Reject

7 Chromatic aberration Follow engineering specification

8 Printing Printing must not have incomplete printing, break off, overlap, uneven thickness,

excessive ink, printing misalignment (1.5mm), printing slanting & crooked (<0.5mm)

Printing color must be comparable to color chip and sample. Follow engineering

specification

9 Logo of panel sticker Printing must not have incomplete printing, break off, overlap, uneven thickness,

excessive ink, printing misalignment (1mm), printing slanting & crooked (<0.5mm)

Printing color must be comparable to color chip and sample.

10 Scratch/Nicks Side A:

(W < 0.1mm , L < 5mm): Only 2 this kind of scratch is accepted

W < 0.1mm , L < 5-10mm :Only 1 this kind of scratch is accepted

Side B:

W < 0.2mm , L < 5mm : Only less than 2 this kind of scratch is accepted

W < 0.2mm , L < 5-10mm : Only 1 this kind of scratch is accepted

Side C:

W < 0.3mm , L < 5mm : Only 3 this kind of scratch is accepted

W < 0.3mm , L < 5-10mm : Only 2 this kind of scratch is accepted

W < 0.3mm , L < 10-15mm: Only 0 this kind of scratch is accepted

Note:

1. Severe scratch which disclose the Natural

2. When light scratching on it, there’s no feeling of obstruction. Also, there should not

be obvious difference in gloss nearby it.

3. Each scratch should be 5cm more far away from each other

4. Front case must be no any scratch