User guide

5 ViewSonic PJ500
Loading the Batteries
Initial Battery Loading
In original packing, the battery is installed in the battery holder of the remote control with protective
film (some of the transparent film is inside the battery Holder).
Pull out the protective film to load the battery.
Replacing Remote Control Battery
1 See the reverse side of the remote control.
1 Pinch the groove and pull out battery holder. See graphic above.
2 Remove the used battery.
3 Install the new battery with “+” side facing up.
4 Push in and click the battery holder.
NOTE: When remote control operation becomes difficult, replace the batteries.
Figure 4: Battery
Warnings
• Incorrect handling of the battery could result in fire or personal injury.
• The battery may explode if not handled properly.
• Use the 3V micro-lithium battery, type number CR2025 only.
• When loading the battery, make sure the plus and minus terminals are correctly oriented as indicated in the remote
control.
• Dispose of the battery in accordance with local laws and regulations.
• Keep the battery away from children and pets.
• When not to be used for an extended period, remove the battery from the remote control.