Technical information

SIIG CyberSerial Single PCI
The SIIG CyberSerial Single port is the second PCI card used on Sable POS systems. Though this card is
more costly than the traditional ISA alternatives or even the dual port card, PCI is better supported by the
operating system and pcAnywhere. Unlike the dual cards, these PCI cards use one IRQ for each card.
The CyberSerial card has shipped in two different version. The early version is a mid-size card while the
later version is a short card. Each of these cards require a different driver and are not interchangeable. The
correct version should have been included with either the computer or I/O card.
Version 2 (at 50% actual size) Version 3 (at 50% actual size)
In order for these cards to function properly with Sable, it is vital that at least one PCI slot be left open
between two of these cards.
Unlike the ISA cards, the PCI cards require a software driver. The CyberSerial card uses a control panel
called “Cyber PCI” to configure the card. In the Cyber PCI control panel, you should have the following set-
tings:
COM IRQ Address
3 5 3e8
4 10 2e8
When only one card is installed, the settings should look like this:
COM IRQ Address
3 10 3e8
16550
16-Byte Buffer
FAST SERIAL
SIIG
V3.0
V2.0
PCI
High Speed Serial Port
CYBER
SIIG
15
revision 0.2.8.7