Technical information

SIIG CyberSerial Dual PCI
The SIIG CyberSerial is the first PCI serial card used on Sable POS systems. Though this card is more cost-
ly than the traditional ISA alternatives, PCI is better supported by the operating system and pcAnywhere.
These PCI cards use only one IRQ for both COM ports.
The CyberSerial card has shipped in two different version. The early version is a mid-size card while the
second version is a short card. Each of these cards require different drivers and are not interchangeable. The
correct version should have been included with either the computer or I/O card.
Version 1 (at 50% actual size) Version 2 (at 50% actual size)
Unlike the ISA cards, the PCI cards require a software driver. The CyberSerial card uses a control panel
called “Cyber PCI” to configure the card. In the Cyber PCI control panel, you should have the following set-
tings:
COM IRQ Address
3 10 3e8
4 10 2e8
The Cyber PCI control panel The Advanced Port Settings
16550
16-Byte Buffer
FAST SERIAL
16550
16-Byte Buffer
FAST SERIAL
SIIG
V2.0
PCI
High Speed Serial Port
CYBER
PCI
High Speed Serial Port
CYBER
SIIG
13
revision 0.2.8.7