Technical information

AMD K6-2/333 processor stall fix

1. Shut down the computer and after the power is off, unplug the power to the computer and remove the

monitor’s connection to the computer. Remove the computer’s cover (there are six screws on the mini-

tower case).

2. Remove the screw holding in the video card. Remove the video card.

3. Locate the “FS” series of jumpers. They should be immediately under the card which you just removed

(see illustration below). The jumpers should be set to:

FS0 FS1 FS2 FS3

1-2 2-3 2-3 2-3

(FS0 should be the jumper toward the top of the case and the 1-2 position being toward the back of the

case.)

4. Replace the video card (make sure it is completely seated) and fasten it down.

5. Locate the “BS” series of jumpers near the RAM and drives (see the illustration below).The jumpers

should be set to:

BS2 BS1 BS0

2-3 2-3 1-2

(BS2 should be the jumper toward the top of the case – which is opposite the “FS” series – and the 1-2

position is toward the back of the case.)

6. Replace the cover and fasten down all six screws. Reconnect the monitor’s cable and the power to the

computer.

BS2

123

BS1

BS0

FS0

FS1

FS2

123

FS3

BACK OF COMPUTER

PCComplete Technical Information for Sable Techs/Installers