User Guide
Table Of Contents
- Introduction
- Shipping contents
- Controls and functions
- Setting up
- Positioning your projector
- Using the menus
- Adjusting your projector’s settings
- Connect the projector to your device
- Different menu options
- M1+ FW Upgrade
- Wallpaper
- Image Settings
- About the aspect ratio
- Auto Keystone
- V Keystone
- Brightness
- Contrast
- Projector Position
- Harman Kardon - Adjusting the audio settings
- Muting the Sound
- Adjusting the Sound level
- Adjusting the Audio Mode
- Adjusting the Light source settings
- Reset All Settings
- Eye Protection
- Viewing different file
- Using the 3D function
- OSD Menu System
- Specification sheet
- HDMI Support Video Timing
- HDMI Support PC Timing
- 3D Support Timing
- USB-C Support Timing
24
Projector Position
Personal preference and room layout will decide the installation location.
Go to Settings > Image Settings> Projector Position
Press < / > to adjust position.
Press OK when nished.
The projector is designed to be installed in one of the following locations:
1. Front Table
The projector is placed near the oor in front
of the screen.
2. Front Ceiling
The projector is suspeneded upside-down
from the ceiling in front of the screen.
3. Rear Ceiling
The projector is suspended upside-down from
the ceiling behind the screen.
NOTT: A special rear projection screen is
required.
4. Rear Table
The projector is placed near the oor behind
the screen.
NOTT: A special rear projection screen is
required.