User Guide

12

To ensure proper funcon of the remote control
follow the steps below:
1. The remote control must be held at an angle
within 30° perpendicular to the projector’s IR
remote control sensor(s).
2. The distance between the remote control and
the sensor(s) should not exceed 8 m (26 .)
 Refer to the illustraon for the locaon
of the infrared (IR) remote control
sensor(s).
IR Receiver
IR Receiver

1. Place the remote control facedown and remove the baery tray from the boom
of the remote control by pressing the side tab and pulling it out.
2. Remove any exisng baery (if necessary) and install one CR2032 baery.
 Observe the baery’s polaries as indicated.
3. Replace the baery tray by aligning it with the base and pushing it back into
posion.
CR2032
OPEN
PUSH
RELEASE
CR2032
OPEN
PUSH
RELEASE

• Avoid leaving the remote control and baeries in excessive heat or a humid
environment.
• Replace only with the same or equivalent type recommended by the
baery manufacturer.
• If the baery is drained or if you will not be using the remote control for
an extended period of me, remove the baery to avoid damage to the
remote control.
• Dispose of used baeries according to the manufacturer’s instrucons and
local environment regulaons for your region.