User Manual

15
Setting
Signal detection Select On to automatically recognition source.
OSD turn o󰀨 Select OSD menu display time.
Data Display the date.
Time Display the current time.
O󰀨 Timer With O󰀨 Timer function On, the display will
automatically turn o󰀨 at a preset time.
On Timer With On Timer function On, the
display will automatically turn on
at a preset source at a preset
time.
Highlight Period item, press
or button to select
Once, Everyday, Mon.~Fri.,
Mon.~Sat. or Sat.~Sun..
Boot on source Power on Source Setting, in MEMORY mode, when
the Poster powered on, it will automatically switch to
the source when it powered o󰀨 last time. otherwise, it
is in setting mode.
No Signal Standby Set the time for no signal standby time.
HDMI EDID Version Select HDMI EDID Ver.
HDMI with One Wire Turn on/o󰀨 enable HDMI_CEC.
HDMI ARC Turn on/o󰀨 enable HDMI_ARC.
The default password is
0000. The unit provides
a super password 2580.
Lock
Set Password Password settings.
Monitor ID Set the ID number for controlling the display via the
RS232C connection.
Power Save Select Power o󰀨 save mode.
Mode1: Press
to put the poster in o󰀨 mode.
Mode2: Press
to put the poster in standby mode.
Mode3: Press
to turn o󰀨 backlight, press again
to wake up the system.
USB Auto Play When the signal is back, the system will be woken up.
Slideshow interval Select slide show time.
Burn-in Protection
Interval
Select Pixel shift time.
WOL Set to ON, the Poster is in standby mode, LAN can
wake up and turn on the Poster.
Boot On Logo Turn on/o󰀨 the rst Power Logo.
Change Logo Select Change Logo item to access and change
Logo.
Note: 1. Save the logo which you are about to change
in the USB stick. The logo le sizes should
be <512K, and rename it as boot0.jpg.
2. Insert the USB stick into the USB port on the
Android board.
Factory reset Reset all settings to factory defaults.