Service manual

3.6 RESOLUTION NOTICE ACTIONS

1. Resolution Notice OSD should show on screen after changing to non-native mode for 30 sec

2. Key button definition:

[1]: Turn off the OSD message.

[2]: Turn off the OSD message and disable Resolution Notice function

3. The OSD should disappear after 10 sec or by pushing button [1] or [2]

4. After the OSD turns off, it will not show on again before next timing change, input change or power off.

5. Resolution Notice function should be disabled when push button [2] under Resolution Notice OSD

6. The “1366x768” will be replaced by actual panel resolution.

3.7 TOUCH™ FUNCTION ACTIONS

1. Execute Auto Image Adjust when new mode detected, and save the settings to buffer for

further use

2. It should be reset by Memory Recall function

(Should not reset by power off, power unplug and others)

3.8 OSD AUTO SAVE

The OSD shall save new settings when it is turned off by the user or when it times out. There shall not be a

separate save

3.9 OUT OF RANGE

While non-defined timing is detected, following OSD message will keeps showing on,

1. If the timing is over spec (Fh, Fv or dot clock), the image shall be blanking, and OSD background shall be

non-transparent.

2. If the timing is inspect but not defined, the image shall be non-blanking.

ViewSonic Corporation

VX2433wm-1

VX2433wm-CN

CONFIDENTIAL – DO NOT COP