Owners manual

23
HDMI1 HDMI2 DVI DisplayPort VGA MediaPlayer Browser
PDF
Player
Custom
HDMI1 O X X O O X X X X
HDMI2 X O X O O X X X X
DVI X X O O X X X X X
DisplayPort O O O O O O O O O
VGA O O X O O O O O O
Media
Player
X X X O O O X X X
Browser X X X O O X O X X
PDF Player X X X O O X X O X
Custom X X X O O X X X O
(O: PIP function available, X: PIP function
unavailable)
5.1.5. Config1 menu
Switch on state
Panel saving
RS232 routing
Boot on source
WOL
Power LED light
Network
Configuration1 reset
Factory reset
Picture
Screen
Audio
PIP
Configuration 1
Last status
Action
RS232
Action
Off
On
On
Action
Action
Switch on state
Select the display status used for the next time
you connect the power cord.
• {Power off} - The display will remain off
when the power cord is connected to a wall
outlet.
• {Forced on} - The display will turn on when
the power cord is connected to a wall outlet.
• {Last status} - The display will return to the
previous power status (on/off/standby) when
removing and replacing the power cord.
Panel saving
Choose to enable the panel saving functions and
thus reduce the risk of “image persistence” or
“ghost-imaging”.
• {Brightness} - Select {On} and the image
brightness will be reduced to an appropriate
level. The Brightness setting in the Picture
menu will be unavailable when selected.
• {Pixel shift} - Select the time interval ({Auto}
/ {10 ~ 900} Seconds/ {Off}) for the display
to slightly expand the image size and shift
the position of pixels in four directions (up,
down, left, or right). Activating Pixel Shift will
disable H Position, V Position and Zoom
Mode in the Screen Menu.
RS232 Routing
Select the network control port.
Choose from: {RS232} / {LAN->RS232}.
Boot on Source
Choose to select source when boot up.
Input: select input source when bootup.
Playlist: select playlist index for Media player,
Browser, PDF player.
0: no play list. Same as switch source from
OSD.1~7: playlist number.
WOL
Choose to turn on or off the wake on LAN function.
Choose from : {Off} / {On}
NOTE
:
• WoL is not supported when power save
mode set as Mode 3 and Mode4.
• System only turn of backlight when DC off in
Mode 3 and Mode 4.
• If user want to power on system in Mode
3 and Mode 4, user can use power on
command of RS232 over LAN.
Power LED light
Choose to set power indicate LED on or off.
Choose {On} for normal use.
Network
Launch Network setup and the input source will be
changed to Custom for Android network setting.
When exit the network setting, input source will be
back to the latest input source.
LED Indicator
LED Status Power Status LED behavior
LED Active Normal ON Green
Sleeping Ambera
RC command RED blinking+GREEN
Schedule on RED+GREEN
blinking(DC Off)
If ON TIME is "--:--", the
LED is not blinking.
Standby/DC power off RED
LED Not-active Switch off Blank
Conguration1reset
ResetallsettingsinConguration1menutothe
factory preset values.
Factory reset
Reset all settings in the OSD menus of {Picture},
{Screen}, {Audio}, {PIP}, {Conguration1},
{Conguration2}, and {Advanced option} to the
factory preset values.
Android settings will also reset when factory reset.