Owners manual

13
4. Operation
NOTE: The control button described in this section
is mainly on the remote control unless
speciedotherwise.
4.1. Start-up and initial Setting
4.1.1. Welcome
Select your language and tap “Start”.
4.1.2. Network Setting
Select Ethernet and it will show
1. Connection Type : DHCP / Static IP
2. IP Address
3. Netmask
4. DNS Address
5. Gateway
Setting completed tape “Next” button to next page.
Youalsocantape“Skip”tocongurelater
4.1.3. Signage Display Settings
UsercanimportthesettinglefromSD,USBor
manual setting. User also can tape “Skip”.
Note:Thesettingleshouldbeputonviewsonic
folderinSDorUSBandthelenameissettings.
db.
4.1.4. Setup Complete
The initial settings are completed. Press “Finish”
and display will reboot automatically.
4.2. Watch the Connected Video Source
See page 8 for external equipments
connection.
1. Press
SOURCE button .
2. Press
or button to select a device, then
press OK button.
4.3. Change Picture Format
You can change the picture format to suit the video
source. Each video source has its available picture
formats.
The available picture formats depend on the video
source:
Press
FORMAT button to change the picture
format.
• {FULL}:Enlargethepicturetollthescreen.
• {NORMAL}: 4:3 format.
• {DYNAMIC}: 16:9 format.
• {REAL}: This mode displays the image
pixel-by-pixel on screen without scaling the
original image size.
• {21:9}: 21:9 format.
• {CUSTOM}:Customdene.