User's Manual

Rev.1.0 Page 88 of 151 VW40-153-006
VIVIX-S 1717N User Manual
AP
Checks and sets AP (Access Point) of detector information.
Item
Description
AP On / Off
Executes or disables the detector AP (Access Point) function.
Frequency
Frequency channel of wireless network
2.4 ㎓
Uses 2.4 ㎓ Frequency. (Up to 13 channels)
5 ㎓
Uses 5 ㎓ Frequency. (Up to 8 channels)
Country
Country code of wireless network (KR, US, EU, JP, CN)
Band
Wireless network bandwidth
20 ㎒
Basic Frequency Band
40 ㎒
Expands bandwidth through channel bonding.
Channel
Wireless network channel
SSID
Wireless network ID
Key
Wireless network key value (Applied to the password only.)
 13 channels can be used in 2.4 ㎓ Frequency.
 8 channels can be used in 5 ㎓ Frequency
 The number of serviceable channels is different according to the configured country.
 Channel bonding is used for enhancing transmission speed. However, the speed may be
slowed down due to the interference of surrounding channels, even if the channels have
been bonded.
 Channel items (+/-) will be activated in case of using 40㎒ frequency bandwidth. You can
set whether to bond channels with the above or below one.
 SSID and Key values of the detector for communicating with SCU wirelessly (WNetwork)
should be set as the same.
 Set SSID and Key values not to be duplicated with those of the peripheral system.
 The maximum value of SSID is 20 letters and the Key is 63 letters. (Minimum Key value:
8 letters). The input letters are limited to capital / small alphabets, “-“, “_” among special
letters and numeric characters.
 Wireless network setting should be done by an engineer who understands the wireless
communication and its related technique. Unless the network is set properly, a
communication error would occur or the image quality would be affected.