User's Manual
Table Of Contents
- Instruction
- Product
- System Configuration
- Installation
- Setting
- Calibration
- Diagnosis, Inspection and Maintenance
- Troubleshooting
- Regulatory Information
- Medical Equipment Safety Standards
- Radio Frequency Compliance Information
- Labels and Symbols
- Guidance and Manufacturer’s Declaration for EMC
- Electromagnetic Emissions
- Electromagnetic Immunity
- Electrostatic Discharge (ESD) IEC 61000-4-2
- Electrical Fast Transient/Burst IEC 61000-4-4
- Surge IEC 61000-4-5
- Voltage Dips, Short Interruptions/Voltage Variations on Power Supply Input Lines IEC 61000-4-11
- Power Frequency (50/60 ㎐) Magnetic Field IEC 61000-4-8
- Conducted RF IEC 61000-4-6 / Radiated RF IEC 61000-4-3
- Information
Rev.1.0
Page 31 of 151 VW40-152-009
VIVIX-S 1012N User Manual
2.3.4 Deco Sheet
VIVIX-S 1012NAW / 1012NBW (Wireless)
Indication
Info.
Description
A
Wireless communication l
ogo
Indicates that this model
can be operated wirelessly.
B
Status indication l
ogo
Indicates the operating state of detector
.
AP Mode, DATA, ACTIVE, POWER
C
Image starting p
oint
Indicates the starting point of an original image.
D
C
enter of the detector
Indicates the central position of
detector.
E
Vieworks logo
Indicates the logo of Vieworks.
F
Certification logo
Indica
tes the certification logos relating to a medical device.
Image starting point (0.0) of this detector is located nearby the tether interface connector.
You can change the displayed direction of an image from the VIVIX Setup program, but
it does not mean that the starting point and direction of the original image are changed.