User's Manual
Table Of Contents
- Instruction
- Product
- System Configuration
- Installation
- Setting
- Calibration
- Diagnosis, Inspection and Maintenance
- Troubleshooting
- Regulatory Information
- Medical Equipment Safety Standards
- Radio Frequency Compliance Information
- Labels and Symbols
- Guidance and Manufacturer’s Declaration for EMC
- Electromagnetic Emissions
- Electromagnetic Immunity
- Electrostatic Discharge (ESD) IEC 61000-4-2
- Electrical Fast Transient/Burst IEC 61000-4-4
- Surge IEC 61000-4-5
- Voltage Dips, Short Interruptions/Voltage Variations on Power Supply Input Lines IEC 61000-4-11
- Power Frequency (50/60 ㎐) Magnetic Field IEC 61000-4-8
- Conducted RF IEC 61000-4-6 / Radiated RF IEC 61000-4-3
- Information
Rev.1.0
Page 125 of 151 VW40-152-009
VIVIX-S 1012N User Manual
7.4 Product Initialization
If the connection status of system is not stable or setting value is not correct, user can initialize the
products.
7.4.1 SCU Initialization
1
Click Configuration button of SCU after running the VIVIX Setup program.
2
Click Factory Reset button in Configuration dialogue.
3
Wait for SCU to be initialized and rebooted automatically.
4
Check whether SCU initialization is completed.
Default value of SCU initialization
Item
Default Value
Network
IP Address
169.254.
2.100
Subnet Mask
255.255.0.0
Gateway
169.254.
2.100
AP
AP On/Off
O
N
Frequency
5
㎓
Country
KR
Band
4
0㎒
Channel
+3
6
SSID
vivix
Key
1234567890
Test Mode
On/Off
Period
Trigger
Method
Packet
Polarity
Auto