User's Manual
Table Of Contents
- Instruction
- Product
- System Configuration
- Installation
- Setting
- Calibration
- Diagnosis, Inspection and Maintenance
- Troubleshooting
- Regulatory Information
- Medical Equipment Safety Standards
- Radio Frequency Compliance Information
- Labels and Symbols
- Guidance and Manufacturer’s Declaration for EMC
- Electromagnetic Emissions
- Electromagnetic Immunity
- Electrostatic Discharge (ESD) IEC 61000-4-2
- Electrical Fast Transient/Burst IEC 61000-4-4
- Surge IEC 61000-4-5
- Voltage Dips, Short Interruptions/Voltage Variations on Power Supply Input Lines IEC 61000-4-11
- Power Frequency (50/60 ㎐) Magnetic Field IEC 61000-4-8
- Conducted RF IEC 61000-4-6 / Radiated RF IEC 61000-4-3
- Information
Rev.1.0
Page 119 of 151 VW40-152-009
VIVIX-S 1012N User Manual
Item
Description
Connection Type
Indicates the connection mode. (Wireless / Tether)
Link Speed
Connection status in the
wired mode. (1000Mbps / 100Mbps)
Link Quality
Link
Quality (Status of the connection quality) value
Signal
-level
Singal strength
Bit rate
Transmission /
reception speed
Frequency
Frequency of the connected
AP (Access Point)
The communication is not running smoothly when the strength of wireless communication
is under the 2
nd
stage. Therefore, it is required to check the surrounding wireless
communication status.
7.1.4 Communication Speed Diagnosis
The communication speed can be diagnosed from the Diagnosis dialogue in VIVIX Setup program.
Item
Description
Image Transmission Time
Image transfer rate test
Download
Download speed of the image (Detector
Workstation)
Throughput Measurement
Transmission measuring test
Time
Transmission time
Bit rate
Transmission rate