User's Manual

Rev.1.0 Page 118 of 151 VW40-152-009
VIVIX-S 1012N User Manual
 If the remaining of battery is under 30% or at the 1
st
level, the system warns low battery
and the detector will be turned off automatically if the battery is being consumed for a
specific period of time. Therfore, it is recommended to change the battery when a
warning message or indicator is displayed.
7.1.3 Wireless Communication Diagnosis
 In case of using the detector with wireless communication way, make sure to check the
status of wireless communication before starting to use. If the status of wireless
communication is bad, the speed of acquiring images will be very slow or failed to acquire
images. Try to check the surrounding wireless communication status not to occur
communication interference. If wireless communication module in the detector has
problems, consult the sales representative in Vieworks or a relevant engineer.
Check the Connection Status
User can check the connection status of wired or wireless detector through VXvue or VIVIX SDK.
Check the Strength of Wireless Communication Signal
The signal strength of wireless communication is provided as 5 stages or percentage (%), user can check it
through VXvue (Vieworks Viewer) and VIVIX SDK.
Level
Level
Link Quality
Meaning
Very Good
5
66 ~ 70
The communication is
running smoothly, and it
ensures performace of the image acquisition.
Good
4
56 ~ 65
Normal
3
41 ~ 55
The communication status is normal, but it does not
ensure performace of the image acquisition.
Bad
2
31 ~ 40
The communication status can become unstable.
Very Bad
1
1 ~ 30
Impossible to communicate normally.
Unknown
0
0
The
communication is disconnected.

You can check the wireless communication state from the Diagnosis dialogue in VIVIX Setup program.