Repair manual

In” round head screw holding small escapement to movement
plate.
D - Remove 2-65 X ¼ In” round head screw and 188-255 spacer at the
other end of movement (rear side).
E - Unhook 118-122 spring from 118-522 reset assembly. Remove
screw 118-118 being careful not to loose 118-117 spacer from
under movement.
F - Remove movement from frame.
23.200 Replace Movement
A - Place camera upside down and set 118-117 spacer in place and
place movement in position and install 118-118 screws. Be
sure locking pawl 118-127 is engaged in 118-112 release latch.
Rehook 118-122 spring.
B - Install two 2-56 X ¼ In” screws.
C - Install one 2-56 X ¼ In” screw and 118-117 spacer.
D - Move movement as far as possible toward switch end of camera
and tighten all four screws.
E - Wind camera, checking operation of movement. If escapement is
not cocking loosen three screws at opposite end from switch
and move movement toward rear of camera and retighten screws.
If there is a tight spot in winding loosen same screws and
move movement forward. Retest.
F - Rehook release spring.
G - Replace top (Section 21.200)