Repair manual

J - Pull shutter blade back a little ways and install crank
assembly 118-524. Crank assembly must be indexed in teeth of
selector plate so that when the lower holes are in position,
(Selector plate slides to the right) the crank must be
pointing down. Install selector knob in “A” position;
selector knob guard 118-152; washers 118-171; and 2-56X¼ flat
head screw.
K - Check freeness and operation of entire assembly. Be sure
shutter pad 118-218 is in proper position with cut out section
toward back and down.
22.300 Replace Front
A - Push selector wire away from center of camera (See photo of
frame) lenses to top position. Release movement and be sure
both panels are in released position. Be sure pressure pad is
in proper position (Section 22.200-C), turn selector knob to a
little shot of “B” position.
B - Place front assembly in position, hooking release button shaft
in release lever, (of movement). Be sure to get flash switch
blade between movement plate and release latch. Be sure
release lever spring is free and not being pinched between
front and frame.
C - With front assembly entered on butt side of frame, turn
selector knob towards “B” as far as possible.
D - Place assembly on bench and turn selector knob back and forth
pressing down lightly until crank assembly enters hole in
frame and front assembly is completely seated.
E - Check to be sure selector wire has entered slot in selector
plate.
F - Check to be sure pad is still in proper position (This is
Important)
G - Check switch for proper position.
H - Install and tighten four 1-72 X 3/12 fill head screws.
I - Hook release spring into hole in frame.
J - Check entire assembly, both in “A” and “B” position.
K - Turn selector knob to “B” position and wind camera until it
locks.
L - Insert on 2 56 X ¼ In” round head screw between release button
shaft and switch boss (See photo). You will need a thin
starter screwdriver for this. Tighten with solid screwdriver.
M - Turn selector knob to “”B” and release shutter.
N - Insert another 2-65 X ¼ In” round head screw at the other end
of front. Tighten with solid screw driver. Note: These two
screws hold the front and top firmly together, and are
sometimes difficult to locate. See Photo.
O - Recheck entire assembly.
23.000 MOVEMENT
23.100 Remove Movement
A - Remove bottom and top. (Section 20.100 and 21.100)
B - Unhook release spring from release lever.
C - Remove two 2-56 X ¼ In” round head screws from back edge of
movement at escapement end. Note: Do not remove 1-72 X 1/8