Repair manual
P A R T T W O
20.000 BOTTOM AND BACK
20.100 To Remove Bottom and Back
Be careful not to disturb switch or movement parts.
20.110 Turn camera upside down and remove 7 screws.
20.120 Lift off bottom and remove back.
20.200 To Replace Bottom and Back
20.210 Be sure camera is timed and flash synchronized before
reassembling.
20.220 Engage cover hinge pin in hinge pin hole in top, and close
back.
20.230 Install and tighten 7 screws. The screws nearest the shutter
release button should be tightened while holding the shutter
release button in.
21.000 TOP
21.100 To Remove Top
A - Remove plastic window above advance indicator and advance
indicator. Remove bottom plate and back according to previous
instructions.
B - Set dials for 1/100 and F5.6, set winding knob in #1 position.
C - First turn to “B” and wind shutter. First top mounting screw
may be seen by looking between flash switch and front casting
and between release button shaft and end of front, when
shutter blade spring is held out of the way, remove this
screw. Release shutter and turn selector knob to “A”. The
second top mounting screw may be seen at the other end of
camera. Remove second screw. See photo of front for screw
location.
D - Loosen magazine retainer screw, swing magazine retainer out of
the way. Remove 310 spring (On camera numbers below 9800
only) and 2-56 fillister head screw from under retainer.
Remove outer set screw on winding knob, loosen inner set screw
then remove winding knob. Lift top, turn flat side of 510
assembly (Assembly on top of magazine spool) toward screw
hole. Remove top.
E - Check view finder lenses and level.
Note: Steps “F Through “J” for cameras without new 311 spring
on magazine spool (Cameras under #9800)
F - Remove 022 spool, 510 assembly, 020 pinion.
G - Lubricate shoulder of 022 spool with light grease and place
311 spring on 022 spool.
H - Place new 39 tooth, 020 pinion over new type 510 assemply and
check for freeness.
I - Install 510 and 020 in frame. Check for tightness.
J - Install 022 and 311 in assembly. Place washers 217K and 033
over 022 shaft and insert 034 pin. Check for freeness of
entire assembly.