User`s guide

i-Pro Viewer
i
-
PRO
Viewer User’s Guide
9/
23
Adding a camera using Server Manager
Single click the “Connect” button on the “General” tab as
shown. This will launch the Server Manager. A single
click on “General” will select (highlight) it for editing. Click “Edit” and rename the “General” entry
to something meaningful to your application. In this example, the “General” tab was changed to
“SWAT Cams”. Single- click“ SWAT Cams” to highlight it. Next right click the highlighted “SWAT
Cams” and select “New Site” which will bring up the “Server Add” configuration box. Select a
name for the camera to enter for “Server Name”. Camera IP addresses are set by the Node knob
on the front panel of the AgileMesh
equipment. In this example, the
“Server Name” will be “Node 1”.
The IP address for a camera
connected to Node 1 is
192.168.224.52 and is entered in
“Server IP”. “DDNS Service” is
not selected. The “Video Port” is set to 7000 plus the last octet of the “Server IP” address, which
is 7000 + 52 or 7052 for this example. The “User ID” and “User Password” are both “admin”.
Click “OK” to save the configuration.
Appendix 1
lists the camera IP addresses for each setting of the
Node knob on AgileMesh equipment.
Note: For AgileMesh dual video nodes, with the Node set to Node
1, consider the “Server Name” for the first camera to be Node 1A
and the second camera to be Node 1B.