User`s guide

i-Pro Viewer

PRO

Viewer User’s Guide

The middle tab on the on the I-Pro Viewer

Setup screen is the “Recording” Tab.

The table below describes the options that can

be configured on the “Recording” tab. The

“Record Interval” should be set to 1 Frame Per

Second (FPS) to conserve disk space.

Record Interval Frame rate to record. (FPS: Frames per Second)

Set to 1 FPS to save disk space.

Folder Specifies the directory to record video. More than one hard

disk can be specified.

Recording Size Shows selected Hard Disk Drive (HDD) Status. If you

select multiple HDDs in the folder above, you can set up the

disk margin for each HDD drive. If the recorded video file is

going to reach the Margin space in a HDD drive, it will

automatically switch the disk drive in alphabetic orders i.e.

C:  D:  E:  etc.

Disk Margin Specifies the HDD free space that I-Pro Viewer will not use

for recording. The range is 100MB to 1GB. I-Pro Viewer

will not write over any existing applications.

Set to 1GB.

Delete Old Files When the all disks are full, this decides whether new files

overwrite the old files or not.

The right tab on the on the I-Pro Viewer Setup screen is the “Sensor” Tab. It is not implemented at

this time.