User`s guide

i-Pro Viewer
i
-
PRO
Viewer User’s Guide
7/
23
Initial Setup
Locate and double-click the desktop icon for I-Pro Viewer to start the viewing
application. i-Pro Viewer can be configured uniquely for each customer application.
The configuration will only be done once. On the “General
tab” at the bottom left corner of the I-Pro Viewer frame,
click on the button that looks like an “ON/OFF” switch. i-Pro Viewer
requires a password to start and stop the application. A password
entry box will appear when I-Pro Viewer starts. The default password
is “1234”.
Click on the “General tab” at the bottom left corner of the
I-Pro Viewer frame. Locate the button that resembles a
wrench. A single click on this button will bring up the “Setup” screen and allow the configuration
of I-Pro Viewer.
There are three tabs on the I-Pro Viewer Setup
screen. The “General” tab, the “Recording” tab
and the “Sensor” tab. The “Sensor” tab is not
implemented in the release.
The table below describes the options that can be
configured on the “General” tab.
Launch on Startup Runs automatically when Windows starts
Auto Connect Connects to camera automatically as soon as it starts.
Language Language selection.
Detect Language Detects the language version of Windows.
Password Set or change the password
Clear Connect Information Deletes all the previous connection information.
Caption Selects the items to be displayed on the On Screen Display
Scan Interval Specifies the amount of time it shows images in the
Sequential Monitoring Mode (1 to 20 sec)
Use Sound for Sensor Alarm Not Implemented