User`s guide

i-Pro Viewer
i
-
PRO
Viewer User’s Guide
10/
23
Additional cameras can be added by a single-click to “SWAT
Cams” (this will highlight it). Next right click the highlighted
“SWAT Cams” and select “New Site” which will bring up the
“Server Add” configuration box. Refer to
Appendix 1
for
the camera IP addresses and video port numbers. Click
“OK” to add the second camera.
Note:
Alphanumeric characters can be used in the Server Name
(camera name), but the Server Name (camera name) must
start with a letter of the alphabet.
To view the video from ALL cameras, highlight “SWAT Cams”
and click “Connect”. To view an individual camera, highlight
“Node 1” and click “Connect”. An alternate method of
bringing up the video from all cameras is to click on
“Connect All” to connect all cameras that have been
configured and are set up.
Click on CH1 (upper left viewing location), This will select and
outline with a yellow rectangle, the first viewing location.
Individual cameras can be added into any viewing location
selected and outlined with a yellow rectangle.
Note: Make sure that a “Disconnect All” is clicked to shut down the video streams from all
cameras before clicking on “Connect All” again.
Multiple clicks to “Connect All” will result in multiple
copies for the same video streams presented by I-Pro
Viewer. Multiple copies of the same video stream could limit the AgileMesh system
performance.