User guide

Chapter 2, Ipro eCapture Controller
2-4 Ipro eCapture User Guide www.iprotech.com
Q1 2014 877-324-4776
• Click . A dialog appears with connection status
information.
If the connection is not established, the dialog will present some
options to try in order to establish the connection.
If the connection is successful, the dialog will state: The connec-
tion was tested successfully. Click OK to close this dialog.
3. From the Queue Manager Integration box, do any of the following:
•Select Automatically Start Queue Manager to start the Queue
Manager when the Ipro eCapture Controller is started. This is the
default setting. It is recommended to leave this option selected.
•Select Automatically Stop Queue Manager to stop the Queue
Manager when exiting the Ipro eCapture Controller. This setting is
deselected by default. It is recommended to leave this option
deselected so that the Queue Manager can continue assigning
tasks to the Workers and processing can continue uninterrupted.
Note: To stop and start the Queue Manager manually from the
Window system tray, do not select either of the above two options.
For more information about the Queue Manager, see Chapter 3,
Ipro eCapture Queue Manager.
4. From the Low Disk Space Cutoff box, do any of the following:
•Network: From the drop-down list, select a value. The minimum
space value is determined by the SQL Server database configura-
tion. This value may change based on the Server that is selected
from the drop-down list in this dialog. The range is from 10 MB
through 100 GB, and No Minimum.
• Worker: From the drop-down list, select a value. The default value
is set to not check drive space. If set with a value, the worker
changes its status to “low disk space” if the drive’s free space falls
below the limit set. The local drive is defined as the drive where
the system temporary directory is configured (%TEMP%)
5. Under User-Interface Settings, select from: