User guide

Running Post Process Batch Operations on Completed Processing Jobs or Data Extract Jobs
www.iprotech.com Ipro eCapture User Guide 5-115
877-324-4776 Q1 2014
tainers) are added to the Selected Sources box, a new Source may not
be added. To remove a container from the Selected Source box, select
the container and click or double-click the container.
8. In the Jobs to Create section, select Data Extract Job and/or Process-
ing Job.
9. Select from the following options:
• Save Selections - Select this option to save the Job type selec-
tions for future Jobs.
• Expedite Job - Select this option to place this job at the begin-
ning of the Job queue.
• Task Table - Select a task table from the drop-down list. The task
table that displays is the most recent task table that was selected
for the Custodian.
10. Click OK. The Jobs appears under the Discovery, Data Extract Job and/or
Processing Job folders in the Client Management tab for the selected
Custodian. The Job(s) appear in the Job Queue pane ready to start.
Running Post Process Batch Opera-
tions on Completed Processing Jobs or
Data Extract Jobs
Post processing batch operations can be performed on completed processing
jobs and data extract jobs. However, post processing operations are not avail-
able for processing jobs that are a part of any export job regardless of the
export job’s status. Unlike QC, images cannot be viewed using this function.
Exit the Processing Job or Data Extract Job in QC before proceeding
with this function. The Processing Job or Data Extract Job cannot be
in QC mode if you want to run the post processing operation on that
same Processing Job or Data Extract Job.