User guide

Setting Processing Job Options
www.iprotech.com Ipro eCapture User Guide 5-61
877-324-4776 Q1 2014
• Setting Processing Job Options on page 5-61.
• Setting the Filtering (Flex Processor) Options on page 5-87.
Setting Processing Job Options
This section describes the available options for both a Standard Processing Job
and a Data Extract Import (Processing) Job.
Setting General Processing Options
Note: The following two options do not appear if accessing the Processing
options through the Options for Project dialog.
Select OCR Pages missing text to OCR pages within documents that are
missing text. It will cause any page that does not have OCR text to have an
OCR task generated for it. Optionally, select PDF page character threshold
to perform OCR on image-based PDFs that may contain a small amount of
embedded text, such as an image key. The default value is 25. The maximum
value is 10000. If there is less than this amount of characters retrieved, the
PDF will be OCRed.
Minimum average OCR confidence level [1-100]: The level range settings
are from 1 up to 100. The default is 50. The OCR Confidence Level is the aver-
age of confidence per document, for all pages within a document on which
OCR was performed. Success or failure of a document for flagging is based on
the average confidence level of the document. If the average confidence level
is below the selected threshold, the document will be flagged in QC with the
OCR Low Confidence Flag.
The Save Settings as Project Default option appears in each Pro-
cessing Job tab. (Any new process/data extract jobs under that proj-
ect will have the project default filters pre-selected. If you elect to
Save Settings as Project Default, it will not change any existing jobs
or other projects; only new jobs.)