No Links

MR20.5000
02AUG07
The face of these panels are 6.75 x 5.75 inches and usually have seven paddle switches with red, yellow or black lens. Other
switch arrangements may be used. A printed circuit board is permanently attached to the back of the switches.
Immediately below is a listing of all replacement components.
Following the replacement components is a listings of replacement panels and existing panels.
REPLACEMENT COMPONENTS FOR COMPUTER-CONTROLLED SYSTEM PANELS
W
CORPORATION
H
H
R
MASTER
AUTOMATIC
LEVELING
AUTOMATIC
RETRACT
ON
OFF
EMERGENCY
MANUAL OPERATION
HORIZONTAL
VERTICAL
5 AMP
LEFT REAR LEFT FRONT
RIGHT FRONT
RIGHT REAR
TO PREVENT DAMAGE FROM OVERHEATING DO NOT HOLD SWITCH ON
FOR MORE THAN TWO OUT OF EVERY FOUR MINUTES.
RETRACT
HOLD
EXTEND
RETRACT
HOLD
EXTEND
RETRACT
HOLD
EXTEND
CAUTION!
BLOCK FRAME SECURELY BEFORE
CHANGING TIRES OR WORKING UNDER VEHICLE.
6
5
4
1
3
2
A bulb is located under all yellow and red lenses
TO REMOVE BULB:
1) Remove lenses by lifting next to paddle.
2) Lift metal tab to pull bulb.
1
R3674
FUSE 5 AMP AGC 5
(5 FUSES PER R3674)
2
RP3654
(2 BULBS PER RP3654)
BULB #73
4
3
RP3656
RP3655
(2 LENS PER RP3655)
(2 LENS PER RP3656)
LENS YELLOW
LENS BLACK
6
5
RP4946
RP3657
(1 LENS PER RP4946)
(2 LENS PER RP3657)
LENS RED LOW VOLT
LENS RED
PART
ITEM
DESCRIPTION
QTY
PANEL, CONTROL AND INDICATOR LIGHTS
FOR COMPUTER-CONTROLLED, HYDRAULIC LEVELING SYSTEMS
(PADDLE SWITCH)