User guide

Tuner Area
User can use the Encoder Vol Knob to select the frequency spacing which is most appropriate
for the area this unit is used in, U.S.A. South America, Europe or Oirt. (Russia Band)
E - 17
broader range of signals. To set the unit to select only strong local stations during automatic
tuning, rotate the Encoder Vol Knob button until "Local" appears on the display.
AV Jack
The panel AV Jack is default as “AV In” source. User can use the Encoder Vol Knob to select
“OUT”. Once “OUT” is selected, the panel AV jack is changed as an AV OUTPUT ( AV OUT )
of the Audio / Video Signal of this unit's Built-in DVD player.
This AV Out selection is useful for user by simply plug and connect to any external
TFT system without any extra installation.
Beep Tone
The beep tone feature allows the selection of an audible beep tone when a button is
pressed. "BEEP TONE On" is the default setting. Rotate the Encoder Vol Knob to select the
"BEEP TONE Off" option
Programmable Turn-on Volume (VOL PGM)
This option allows the adjustment of the volume level of the radio will automatically assume
when turning on. "VOL PGM 12" is the default setting. To program a specific turn on volume
level, use the Encoder Vol Knob to select "VOLUME LEVEL” within 5 seconds.
Rear Speaker On/Off (Rear Spk)
Rear speaker is set to 'ON' by default. If OFF is selected, the rear speaker's audio output will
be TURNED OFF. This function is useful while listening with the HEADPHONE and user
doesn't need Rear Speakers sounds output through rear speakers. Select “ON” to reactivate
the rear speakers sound output
Inter Amplifier On/Off(Inter Amp)
This is a option selection for user to turn the unit's built-in Amplifier system on or off. “OFF”
is the default setting. This option is useful for user if connected to an external Amplifier & the
user do not want audio output of the built-in amplifier system.
: When the Rear Speaker is 'OFF', the Audio Function, 'FADER', will not be functional
Tuner Set
User can use the Encoder Vol Knob to select between Local or Distance mode.
This feature is used to designate the strength of the signals at which the radio will stop
during automatic tuning. "Distance" is the default setting, allowing the radio to stop at a
Parking
This option is useful if user FORGOT that the “PARKING WIRE” is not properly connected.
There will be no Video output if the Parking Wire is NOT PROPERLY CONNECTED to the Hand
Brake Switch. The LCD will display “PARKING On” and will stay on the LCD for 5 seconds. User
can use the Volume Up or Down button to turn “PARKING” to “OFF” within the 5 seconds time
out. Once “Parking” is changed to “Off”, the TFT monitor will display the video signal
regardless even if the Parking Wire is NOT CONNECTED !
The “PARKING On” will keep scrolling through the LCD for every 20 seconds if user
does not select “PARKING Off” under the DVD or AV-In Modes!
For quick access Parking “On” & “Off” . User can Long Press ‘Mute’ button on the
Front control panel or Remote control