User manual

Dual Alarm Clock Speaker Docking iPad/iPhone/iPod
18
BasicOperation
ConnectPower
- Risk of product damage!
- Ensure that the power supply voltage
corresponds to the voltage printed on
the back or the underside of the unit.
- Before connecting the AC power
cord, ensure you have completed all
other connections.
Connect the AC power cord to the wall socket.
Power
You can use all the functions on the top of the unit or
the remote control after connecting to power supply
(called Standby Mode).
TurnOn
Press button to turn the system on from standby
mode.
When turning the system on, the system will
continue in the mode it was in when it was
turned off last time.
TurnOff
Press button again to turn the system off and go to
standby mode.
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended
period of time.
SetTime
The built-in clock shows the correct time in the display.
1. In standby mode, press and hold the CLOCK button
for some seconds, hour indicator will blink.
2. Set the hour with the button or button.
3. Press theCLOCK buttons to conrm, minute indicator
will blink.
4. Repeat steps 2-3 to set the minutes.
SettheAlarmTimer
You can set two alarms which go off at different time.
1. Ensure that you have set the clock correctly.
2. Press and hold ALARM1 or ALARM2.
3. Press / on the remote control to select an alarm
sound source: iPod/iPhone/iPad, FM tuner, or buzzer.
4. The display will show volume level and ash. Press
the / buttons on the remote control to adjust the
volume no less than Vol 8.
5. Press ALARM 1 or ALARM 2. The hour digits begin
to blink.
6. Press / repeatly to set the hour.
7. Press ALARM 1 or ALARM 2. The minute digits begin
to blink.
8. Repeat steps 6-7 to set the minute.
ActivateandDeactivatetheAlarmTimer
Press ALARM 1 or ALARM 2 repeatly to activate or
deactivate the timer.
RepeatAlarm
You can press to adjust the interval to repeat alarm.
When the alarm rings, press SNOOZE/DIMMER. The
alarm repeats ringing 9 minutes later.
StopAlarmRing
When the alarm rings, press the corresponding ALARM
1or ALARM 2. The alarm stops but the alarm settings
remain.
ViewtheAlarmSettings
Press ALARM 1or ALARM 2 to view the alarm settings.
Setthesleeptimer
This unit can switch to standby automatically
after a set period of time.
Press SLEEP repeatedly to select a set period of time (in
minutes).
when selected the “00”, then could exit the
sleep mode.