Installation Manual

67
5350 485 GB 08/2007
Scanning information
Subject to connected components, you can scan current temperatures and operating
conditions.
Press the following keys:
Display indication Explanation Notes
1 20ºC Outside temperature Display only if an outside
temperature sensor is connected
3 65ºC Boiler water -
temperature
5 50ºC DHW temperature Display only if a DHW cylinder
is installed.
5 45ºC DHW temperature Display only if a solar heating
for solar operation system is connected.
6 70ºC Collector temperature Display only if a solar heating
system is connected.
003572 h Burner hours run The hours run can be reset to 0
by pressing . The hours run
displayed are only approximate
values.
030417 Burner starts The number of burner starts can
be reset to 0 by pressing
030417 Fuel consumption The fuel consumption can be
reset to 0 by pressing
Hours run - solar The hours run can to reset to 0
000850 h circuit pump on the Vitosolic solar control unit.
The hours run displayed are only
approximate values.
1.
653
°C
-
For boiler water temperature
2.
for additional scans
+
i
_
3.
to end scanning
OK
Vitoden 200-W pages 44 - 4/9/07 7:56 pm Page 24