Installation Manual

51
5350 485 GB 08/2007
Electrical connections (cont.)
Routing the connecting cables
Note
If connecting cables touch hot components they will be damaged.
When routing and securing connecting cables on site, ensure that the maximum
permissible cable temperatures are not exceeded.
Low voltage connections
A
230 V mains connections
B
Internal extension H1, H2
C
Main PCB
D
Communications module
E
Cable grommet for power supply
F
Plugs for connecting the DHW
cylinder temperature sensor to
the cable harness.
Remove the existing cable
grommet when using larger
cross-sections (up to Ø 14mm).
Secure the cable with cable
grommet (black) integrated
into the casing base.
5
F
Vitoden 200-W pages 44 - 4/9/07 7:56 pm Page 8