Operating instructions

53
5603 882 - 01
Pyrotec Installation & Operating
Operation
Pyrocontrol Control System (continued)
Screen 2, Alarm list
Touching the red Alarm line soft touch key (in Screen
1) opens Screen 2 (Alarm List with alarm logs, red). All
error messages which have been registered but not yet
acknowledged are listed here.
Touching an alarm log line allows the respective error
message to be displayed in detail or acknowledged.
A history of acknowledged error messages can
be called up in Screen 2.
Area of Screen 2 Description
Screen
Screen title, e.g. “Alarm List”
User status (top right)
Alarm logs (red) in rows
according
to time
Back button (back to Screen 1)
Display alarm logs
Acknowledge all
Top
Centre
Bottom
The “Acknowledge all” soft touch key (bottom left)
acknowledges error messages listed in the centre of the
Screen. The cause of the error should be remedied before
acknowledging the error message. Otherwise the error
message will continue to be maintained. (It will be
shown again in the Alarm List after a short period of time).
Touching the soft touch key “Display alarm log” (bottom
right) will list all past error messages. The soft touch key
“Ascertain alarms in history” is displayed in the lower
left of this new page. By touching this soft touch key,
the period for which the alarms to be displayed can be
specified.