Technical data

10
6 The ECOTRONIC control system
6.1 General information
The ECOTRONIC facility control system is a de-
centralised microprocessor system (CAN-BUS)
developed by KÖB with various modules that are
connected by a data transmission line.
Its function
The ECOTRONIC records all the data relevant to
operation and controls the supply of and demand
for heat.
Thus the boiler plant is continuously monitored
during all the operating phases and kept within an
optimum range in terms of emissions.
Factory settings (pre-settings)
All the parameters in the ECOTRONIC, such as
set point values and switching times, are pre-set
and can be called back up at any time. The fig-
ures for the factory settings are given in brackets
for the various parameters.
6.1.1 Replacing the battery
There is a battery built in beneath the removable
lid on the control module (type: Panasonic Lith-
ium BR2330). It is for buffering the time, date and
settings.
- The battery needs replacing every five
years!
- Do not disconnect the mains voltage while
changing the battery (do not turn off master
switch)!
6.2 The functions of the keys
F1 (PYROT Wood)
Switch WOOD operation on and off
F2 (PYROT Oil)
Switch OIL OPERATION on and off
F3 (PYROT Parameters)
Setting parameters, set point values, the date and
time
F4 (PYROT Loader System)
Setting of cycle switchover switching, advance-
flow and post-flow times
F5 (Group 1)
Setting parameters and set point values
(heat distribution, Group 1)
F6 (Group 2)
Setting parameters and set point values
(heat distribution, Group 2)
F7 (Group 3)
Setting parameters and set point values
(heat distribution, Group 3)
F8 (Group 4)
Setting parameters and set point values
(heat distribution, Group 4)
< Go one page to the left in menu masks
> Go one page to the right in menu masks
∧ Go one line up
(Only possible when the scroll up symbol Ï
is displayed.)
∨ Go one line down
(Only possible when the scroll down symbol
Ð is displayed.)
+ Change numeric values and set point val-
ues
- Change numeric values and set point val-
ues
OK Adopt (acknowledge) settings and/or
changes
The following applies to the F3, F4, F5, F6, F7
& F8 buttons:
- Pressing once will take you to the respective
menu. As feedback, the relevant LED will blink.
- If a set point value is changed and not con-
firmed with "OK", then it will not be adopted.
- Pressing the function button again will bring
back the standard display.
- When no button is pressed for a period of sixty
seconds, the standard display automatically
reappears.
BE SURE TO NOTE:
Depending on the design and setting, some
menus and texts do not appear.