Technical data

Arrangement of the electrical wiring on the Pyrot
(Recommendation for the electrician; not included in the scope of delivery)
KÖB & SCHÄFER GmbH, Flotzbachstr. 33, A-6922 Wolfurt, Tel. [phone], Fax 65707, E-Mail: [e-mail]
Technische Änderungen vorbehalten
1/1
2005-10-06_E
Screw cable channel (metal design) onto the foot plate
on top of boiler with minimum distance of 10 mm.
Fasten cable channel (metal design)
on casing with minimum distance of 20
mm.
Cable channel (metal design) over en-
tire width of boiler: fastening on the
bottom of the boiler (it is not water-
bearing).
Arrange lines in protective cable hose with sufficient leeway to
open and close the door (mind the door stop).
Lines arranged in metal pipe with
minimum distance of 150 mm to
the base. Use support with cable
routing for light barrier. No support
on base
.
Mount cable channel (metal design) with minimum dis-
tance of 200 mm to the feed auger: no support on the
feed auger.