Installation Pocket Guide

Viega... The global leader in plumbing and heating systems.
301 N. Main, 9th Floor • Wichita, KS 67202 • Ph: 800-976-9819 • Fax: [phone] • E-Mail: [e-mail] • www.viega.com
PI-PF-520531 0511 (Mounting the MINIBLOC)
Product
Instructions
PureFlow
®
MINIBLOC™ Mounting Instructions
The MINIBLOC shall be installed using the MANABLOC
®
Installation Instructions (included) and this
instruction sheet:
1. For proper bracket spacing, measure distance between the center ribs of the rst and last MINIBLOC module.
Mark this distance on the selected mounted surface.
2. Align the outside edge of each bracket within each end mark. Mounting brackets shall be mounted level and
parallel to each other before afxing the MINIBLOC manifold. NOTE: Use both mounting brackets provided
with each MINIBLOC manifold. Ensure the mounting surface is suitable to support the weight of the
manifold and attached tubing when filled with water.
3. Use two wood screws per bracket, 1" or longer, to prevent misalignment.
4. Position bottom metal tie-rod into the bottom clip of the mounting brackets then roll manifold toward top clip.
The MINIBLOC may be mounted either vertically or horizontally.
5. Complete mounting by rmly pushing the MINIBLOC toward the top clip of the mounting brackets
which should spread and snap over top metal tie-rod.
1 2
4 5
3
Vertical Mount
Horizontal Mount