Install Instructions

Mounting the ManaBloc
45 of 88
IM-PF 724596 1021 PureFlow Water System (EN)
3. Standing behind the stud wall, hold the ManaBloc facing away from
you and align the top of the UPPER mounting strap to the line on the
stud that you made in Step 2. Loosely attach this mounting strap 󶈶ush
to the back outer edge of one stud using a ¾" or longer drywall or
other suitable wood screw (A) (see illustration to left).
4. Line up the LOWER mounting strap with the back outer edge of the
stud and attach it in the same manner (B). Attach the remaining strap
ends (C and D) to the other stud, and tighten all screws.
5. Standing in front of the wall, using a framing square or straight edge,
mark the center line position of the top and bottom ports onto both
studs (see illustration).
6. Detach the ManaBloc from its mounting straps (or 1x4s) and remove
it from the installation area to prevent wood chips or other debris from
falling into the unit.
7. Transfer the port location marks made in Step 5 to the insides of the
stud cavity using a square and pencil.
8. Measure 1⅝" from the mounting surface. Draw a vertical line on the studs
that passes through each of the horizontal port center lines marked in
Step 7 (see illustration to left). Be sure to mark the inside of both studs.
A residence intended for disabled persons may require that
the ManaBloc be mounted lower in the wall to provide access.
Attach
here
󶈵rst
(View from back of wall)
Mark the centers of the top and bottom ManaBloc ports (A, B)
1⅝"