Instruction Manual

2.2 Intended use
2.2.1 Areas of use
The drain is designed for small to medium volumes of water, which
occur in e. g. residential building.
Technical information, see
Ä Chapter 2.3.2 „Technical data“ on page 9.
The drain with vertical drain socket is suitable for installation in drill
holes and can be used in low floor construction heights from 20 mm to
105 mm.
The water seal level of 30 mm and the small drainage
capacity do not meet the specifications pursuant to the
standards and regulations. See Ä „Regulations from sec‐
tion: Fields of application“ on page 6.
Check if the drainage capacity is sufficient before mounting!
2.2.2 Media
The drain is intended for draining of household-type wastewater in con‐
stant operation, see
Ä „Regulations from section: Media“ on page 6.
n The short-term temperature of the wastewater may reach up to
95° C. The temperature must be considerably lower in constant
operation.
n The pH value must be higher than 4 but lower than 10.
It is not permitted to introduce wastewater which would damage the
product material.
2.2.3 Drainage capacity
Drainage capacity at an accumulation height of 20 mm above the grate:
0.4 l/s
The values are dependent on the total height (H) of the drain unit.
10
20
Product information
Advantix bathroom drain 7 from 22
https://tm.by
Интернет-магазин TM.by