Install Instructions

IM-PR 566442 1114 (Design Manual)
182
C.3 Layout planning
Place the Traks for the most even heat distribution.
Dimensions in drawing are based on standard 2"x8", 2"x10" or 2"x12" floor joists on 16" centers. Adjust
spacing as needed when using engineered joists or different spacing.
Avoiding obstructions
It is important not to install the Traks around objects that will restrict the tubing from being installed into
the Traks. In the example below, if the Traks were run on the inside of the dropping pipe, you would find
that the tubing would be unable to be snapped in. This is why the Traks are shown going to the outside of
the dropping pipe.
1½" 1½" 1½" 1½"3½"4½"3½" 3½"