Product Overview

7 of 10
Product
Instructions
PI-PR 566490 0514 (Zone Valve)
Viega LLC, 301 N. Main, 9th Floor • Wichita, KS 67202 • Ph: 800-976-9819 • Fax: [phone]
Viega ProPress Insertion Depth Chart
Tube Size ½" ¾" 1" 1¼" 1½" 2"
Insertion Depth ¾" ⅞" ⅞" 1" 1
7
/16" 1
9
/16"
Read and understand all instructions
for installing Viega ProPress fittings.
Failure to follow all instructions may result in extensive
property damage, serious injury or death.
1. Cut copper tubing at right angles using
displacement type cutter or fine-toothed steel saw.
2. Remove burr from inside and outside of tubing to
prevent cutting sealing element.
3. Check seal for correct fit. Do not use oils or
lubricants.
4. Mark proper insertion depth as indicated by the
Viega ProPress Insertion Depth Chart. Improper
insertion depth may result in improper seal.
5. While turning slightly, slide press fitting onto tubing
to the marked depth. Note: End of tubing must
contact stop.
6. Insert appropriate Viega jaw into the pressing tool
and push in holding pin until it locks in place.
7. Open the jaw and place at right angles on the fitting.
Visually check insertion depth using mark on tubing.
8. Start pressing process and hold the trigger until the
jaw has engaged the fitting.
9. After pressing, the jaw can be opened again.
10. Make sure to properly test the system once all
connections are made. See page 9 for testing
instructions
1 2 3
4 5 6
7 8
9
Making a ProPress connection