User's Guide

Note: This device is professionally installed on site by the Vie Technologies team. It is only connected
to a computer USB port for less than 5 minutes. Then the cable is detached and permanently
mounted on the industrial machines to collect data. There are no emissions from the device
until activated by the installation team, as the internal 3V battery has not been electrically
connected. Once the EUT activates the cable is immediately removed
After setup the non-standard USB cable is removed and the OPA mote is powered from the
internal non-rechargeable battery
NOTICE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement:
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Ce dispositif contient les émetteurs/récepteurs autoriser-exempts qui sont conformes au permis RSS
exempt du Canada d'innovation, de la Science et de développement économique. L'opération est sujette
aux deux conditions suivantes:
(1) Ce dispositif peut ne pas causer l'interférence.
(2) Ce dispositif doit accepter n'importe quelle interférence, y compris l'interférence qui peut
causer le fonctionnement peu désiré du dispositif.