User's Guide

OPA MOTE USER GUIDE
Model: M01C100R03
This document is a User Guide for the second generation BLE OPA mote, model number M01C100R03,
FCC-ID: 2AQ6J-M01C100R03, IC-ID: 24331-M01C100R03.
STEP 1: Connect the modified micro USB to USB cable, supplied by VIE Technologies, to the OPA mote.
DO NOT USE A STANDARD CABLE
STEP 2: Connect the USB end of the cable to a 5V power supply. The OPA mote is now active and able to
transmit.
STEP 3: Verify that the OPA mote is turned on and transmitting by discovering its ID through the mobile
application.
STEP 4: Prepare the surface to which the OPA mote will be attached as follows –
a) Use a 120 grit sandpaper, preferably with a Dremel tool (not provided), to prepare the metal
surface for OPA mote adhesion.
b) Clean the sanded surface with ethanol.
c) Let the ethanol evaporate.
STEP 5: Apply epoxy to both the metal surface and the bottom of the OPA mote.
STEP 6: Attach the OPA mote to the metal surface and hold tightly for 3 minutes.
STEP 7: Return to the OPA mote after 20 minutes to verify that the epoxy has cured and the mote is
firmly affixed.