User guide

5. Using the Home Page
36
Controlling the Remote Camera
The Remote Camera Control tab on the VidyoRemote Advanced Home page enables you to control the
camera at the remote sites but only if those sites have Far End Camera Control enabled. That is, the remote
sites must have their systems configured to allow you to control their camera.
To control the remote camera with the VidyoRemote:
1. Click the Show Controls button on the VidyoRemote Advanced Home page.
2. Click the Remote Camera Control tab.
3. Do any of the following:
Click…
To…
The Start/Release button
Toggle between taking control and releasing control of the
remote camera.
The Next Camera button
Select the next site’s camera.
The Select Camera button
Select the camera of the site that’s shown on the display.
The Pan/Tilt Camera left, right,
up, or down arrows
Pan the remote camera (move it left or right) or tilt the remote
camera (move it up or down).
The Zoom up or down arrows
Zoom the remote camera in or out.
For example, if you are in a conference with a number of participants and you want to control the camera
at the New Jersey participant’s site, these are the steps you would take:
1. Click the Start/Release button to take control of the remote camera.
2. Click the Next Camera button until the participant at the New Jersey site is shown on the display.
3. Click the Select Camera button to select the camera at the New Jersey site.