Instruction manual

Remote Control Software VIDRE LCD Monitors
This mode displays three inserts, one each for luminance waveform, PbPr waveform and PbPr
vector, inserted at the right hand side.
Y+Audio Waveform/Phase:
This mode displays three inserts, one each for luminance waveform, Audio waveform and
vector of two channels, inserted at the right hand side.
None:
No waveform on the screen.
Select audio channels for Audio Measure
In the mode of “Y+Audio Waveform/Phase”, Audio Waveform and Phase are based on the
audio channels you selected from SDI signal.
The drop-down list is shown as following:
Off/ CH1&2/ CH3&4/ CH5&6/ CH7&8
Adjust transparency of Waveform Background
Adjust transparency value of Waveform Background. The image can be blocked more or less by
this adjustment.
Put the mouse on the cursor and drag it to the assigned position; or you can fill in the certain
value ranging from 0 to 100, and then press “Enter” on keyboard. “0” stands for full
transparency and “255” stands for opacity.
Disable OSD (Full screen)
Check the box, all on-screen-display elements disappear, so the signal image is displaying in
the full screen mode.
Uncheck the box, the checked elements appear on the screen. Meanwhile, the status of each
on-screen-display element can be set individually.
7.3.8 OSD Layout management
All configured parameters can be saved as a template. System provides up to four templates
for quick application of different occasions.
Click one of four buttons, for example, click “Template 1”. A message box will appear.
Enter the name of template in the blank area at the top of message box, and click “Save”
button at the bottom. So the name of the button is changed to the one you edited, not
“Template 1” any more.
Click the template which is saved already, and a message box appears to show the status of its
each parameter. You can apply the template, or delete the template. After you change its
parameters, even its name, press “Save” button to submit the new data.
Apply: Click this button to apply the relevant parameters.
Delete: Click this button to delete the relevant parameters.
Operation Manual Page 29 of 44