Instruction manual

Remote Control Software VIDRE LCD Monitors
Check the box “UMD”. It will be shown within the channel, otherwise, not.
Attach UMD and Audio meters to edge:
Check the box, UMD bar and audio meters are attached to the edge of screen which makes the
video image be shown completely. If not, UMD bar and audio meters are overlaid on the
image.
Transparency of Audio meters and UMD:
In this area, users can modify the transparency of audio meters and UMD. Put the mouse on
the cursor and drag it to the assigned position; or you can fill in the certain value ranging from
0 to 100, and then press “Enter” on keyboard. “0” stands for full transparency and “100”
stands for opacity.
7.3.3 Tally Display
This function is reserved so far.
7.3.4 AFD Display
AFD Display:
Check the box and AFD information will be overlaid on the top of the screen, otherwise, not.
AFD information is shown in the form of picture, according to the AFD code inside of input
signal.
7.3.5 Safe Marker
The SDI processor allows to insert Safe Markers.
Safe Area Mode:
The picture of SD-SDI signal is marked with 16:9 safe area markers, and the picture of HD-SDI
signal is marked with 4:3 safe area markers.
Mode Description
None: No safe marker on the screen
Mask & Line: Apply both mode
Mask: block the image with Mask
Line: Marker showed with lines
Transparency of Safe Area:
Adjust transparency value of Mask. The image can be blocked more or less by this adjustment.
Put the mouse on the cursor and drag it to the assigned position; or you can fill in the certain
value ranging from 0 to 100, and then press “Enter” on keyboard. “0” stands for full
transparency and “100” stands for opacity.
7.3.6 Input Format Display
The format of the input signal can be displayed at the upper left. Check the box, and input
resolution/format will be overlaid on the top of the screen, otherwise, not.
7.3.7 Waveform Display
Choose Waveform Mode
The system supports display of real-time waveform and vector overlay. There are three options
selectable in a drop-down list.
They are “None”, “Y+PbPr+Vector”, and “Y+Audio Waveform/Phase”.
Y+PbPr+Vector:
Operation Manual Page 28 of 44