Instruction manual

General Description VIDRE LCD Monitors
2.2.4 Restart Button
To restart the SDI signal processor use a push pin to press the button named RESTART. The
function of the button equals to turn off. Probably around 5 seconds the unit restarts using the
last settings.
2.2.5 Default Button
To set the SDI signal processor back to default modes use a push pin to press the button
named DEFAULT/RESOLUTION for several seconds until the DVI output disappears.
The parameters at the internal web page will be restored to default settings, including the IP
address and user password.
The default IP address is 192.168.1.76, and the default password is 000000 (six zeros).
2.2.6 Resolution Button
To select different display resolution of the signal processor use a push pin to press the button
named DEFAULT/RESOLUTION shortly.
The output resolution toggles between mode 1280p60, 1080p60 and AUTO.
Operation Manual Page 11 of 44