User`s manual

☞ If there is no hard disk installed yet, press “Exit” button. If there is hard disk installed
already, press “Enter” to start formatting of the hard disk.
☞ Upon formatting finished, “Exit” button should be pressed, such that the unit will be shut
down automatically and restarted again. After restarting, the unit will go into normal operation
Warning: Formatting will erase all data on the hard disk(s). Before conducting the above
procedure, operator should double check that the data on the installed hard disk(s) can be erased.
WARNING :
HDD does not exist, or, is not initialized !!
If HDD does not exist, press
〈
EXIT
〉
If HDD is not initialized, press
〈
ENTER
〉
FDISK OK
FORMAT OK
MADIRS OK
Initialized completed,
Press
〈
EXIT
〉
to power off
36