User`s manual

The unit’s system password is a combination of numeric digital between 0 and 9. Numeric key on
remote controller or front panel can be used to enter the password. On entering of the system password,
for security reasons, the on-screen indication is represented by “*”.
The ex-factory default system password is “0000”. It is strongly recommended to change the system
password before putting this unit into actual operation (please refer to later section of this manual for
procedure of changing the system password).
1、System Setting
After entering of system password, the screen prompt will be changed as follows:
1.1System Password
By highlighting the “Password” and pressing “Enter”, operator will be prompted to input the new
password. Use the numeric key on remote controller or front panel, to enter a combination of 4 nos.
digits from 0 to 9.
The default password is “0000”, Enter the new password again.
 Password
 Language
 Time set
 Date format
 OSD format
 Default setup
 SW Update
〔Enter new password〕
： __ __ __ __
〔Re-enter password〕
： __ __ __ __
13