Specifications
81
VX 2200
Digital System “Two wire” BUS audio - “Six wire” BUS video
Art.5178
Intelligent voice switched hands free intercom with buttons to control “answer/end conversation”, “door open”
(programmable duration), “privacy on/o” (programmable duration) and “service” button. In addition there are 4
LEDs to indicate the status of “answer/end conversation”, “door open/closed”, “privacy on/o” and auxiliary
“service” status. Call tone and loudspeaker volume controls are also incorporated on this model.
Art.VR5178
Same features of Art.5178 but vandal resistant version: the “service” button that is missing, is replaced by the
“privacy” button that works also as “service” button. Adjustments and programmable functions are the same but
are carried out in a dierent way. Vandal resistant version is for ush mount. This version is made from a brushed
stainless steel plate, 2.5mm thickness, to which, in the back side, is secured the intercom circuitry. The intercom
includes the ush mounting box comprised of xing screws.
Art.3371
Special digital videophone with electronic call tone, Door opening/Concierge-call button, camera recall button,
3 service buttons, privacy of speech and alarm input (option).A local door bell can also be connected which will
produce a dierent call tone melody (Not available when using full isolation). Depending on the dip-switch
settings it can work on systems with coax video or systems with balanced video signal. Also available with elec-
tronic “ON-OFF” timed privacy push button, “DOOR OPEN” and “PRIVACY ON” leds (Art.3376).
Art.VX2206 - Digital BUS Exchanger
For use with two level systems enabling more than one speech path (One per internal block). For videointercom
systems is required the VX2206/V.
Art.VX2210A-1/A
Digital Concierge Unit for intercom systems
The VX2210 allows the operator to handle and to transfer the calls from and to the users. Depending on the
selected operating mode (day-night-o), it is possible to carry out dierent functions from the concierge. For
video intercom systems, it is necessary to use VX2210-1/V (As VX2210-1/A with additional at screen monitor).
An RS232 input to a PC is also available.
Art.2280-1
“2 wire” Bus INTERFACE
The Art.2280-1 enables the connection of the VIDEX Telephone Interface (Art.280N1) or the VIDEX PABX inter-
face (Art.275/2W) or the VIDEX apartment station (Art.500MM) onto the VX2200 system “2 wire” Bus. Please, see
“Telephone Systems” in this catalogue.
Art.3161B
Low cost intelligent intercom with electronic call tone (3 level volume), “door open” and “service” push buttons. It has
a reduced number of features than the 3171 (see VX2200 section). Local bell input (requires an additional wire).
Art.3171, 3172, 3176
Intelligent Intercom with electronic call tone (3 level volume), “door open” and “service” push buttons.
Programmable melody and number of rings. Plus “privacy ON-OFF” switch Art.3172. Plus “timed privacy ON-OFF”
push button, “door open” LED and “privacy on” LED, Art.3176.
Art.2206N
Block exchanger for audio/video door entry systems.
The Art.2206N has been developed from the Art.2206A and 2206V (BUS exchange devices) to give greater
system exibility in one and two level system design and permits far longer cable runs. The 2206N can be used to
distribute the system BUS or used where the installation is greater than 180 apartments. The 2206N allows mul-
tiple speech paths on two level systems or on installations with a main digital entrance panel and a number of
digital or functional secondary block or sub entrances with up-to 998 apartments. This module can also be used
on installations where the existing cable cross section is found to be too small.
Note: main door stations used with Art.2206N must be digital panels (8202 or 4202 and related versions) with rmware release 5.0 or later.